Rules · Doors & windows · Proportion
Divide the height from floor to ceiling into three and a half parts and give two and a half to the opening; make a Doric door five and a half twelfths as wide as it is high (an Ionic one two-fifths), and narrow it slightly at the top.
h = 2½⁄3½ H; Doric w = 5½⁄12 h, Ionic w = h ÷ 2½; top narrowed by ⅓, ¼ or ⅛ of the jamb as h ≤ 16, ≤ 25, ≤ 30 ft
Vitruvius proportions the temple doorway from the room it serves, then its width from its own height, and only then its trim: jambs (the Ionic ones a fourteenth of the height, dressed with three fasciae), a lintel as high as the jamb is wide at the top, a frieze and a projecting cornice; Ionic doors add consoles at the sides. Morgan’s text does not state the Doric jamb width; the model uses a twelfth of the height, an editorial assumption.
The taper (the opening narrower at the top than at the bottom, for all but the tallest doors) is a Greek feature, seen at the north porch of the Erechtheion. It gives the doorway the same slight pyramidal stability as the inclined columns of the temple.
A beam is squeezed along its top and stretched along its bottom; stone resists squeezing well but stretching badly, so a stone lintel must be deep in proportion to its span and cannot be long. Doubling the span quadruples the stress from its own weight.
σ ≈ ¾ ρ g L² ⁄ d (self-weight) · + ≈ 0.43 ρ g L³ ⁄ d² (a wall above)
In a bonded masonry wall the courses above an opening corbel over it of their own accord, so the lintel carries roughly the triangle of wall with sides rising at 60° from its ends; everything above that triangle arches onto the jambs.
load ≈ equilateral triangle on the span: W ≈ 0.43 · L² · t · ρ g
Cut a shaft with sixteen shallow flutes or facets, give it a square abacus and a low round base: the “proto-Doric” column of the Middle Kingdom rock tombs at Beni Hasan.
An arch pushes outward on its supports as well as down. For the same load and span the horizontal push grows as the rise falls: halve the rise and you roughly double the thrust.
H ≈ w·s² ⁄ 8f (uniform load w per metre, span s, rise f)
Over a doorway or window spanned by a lintel, turn an arch in the wall above so that the weight of the masonry is carried round the opening onto the jambs, leaving the lintel to carry only the small triangle of wall beneath the arch.
Raise the central nave above the lean-to roofs of the aisles and pierce the upper walls with a row of windows, the clerestory, so that the middle of a wide hall is lit from high on both sides.
nave height ≈ 1½–2 × nave width; one window over each bay of the arcade
Cite this page Chris Paton, “The door from the height of the room”, The Textbook of Architecture, https://textbookofarchitecture.com/rule/doorway-from-room-height. Text, drawings and models licensed under CC BY-NC 4.0.