Give each rafter span a fixed slope, increasing from the eaves to the ridge: half-pitch (5 jǔ) for the eave span, then about 6½ or 7, 7½, and 9 tenths for the span below the ridge.
rise of span k = run × (0.5, 0.65, 0.75, 0.9) for four spans
The Qing method works from the eaves upward rather than from the ridge downward: the total rise is whatever the sum of the spans produces, not a fixed fraction of the depth. With more purlins and steeper upper spans the roofs of Ming and Qing Beijing are higher and more sharply curved than those of the Song, their silhouettes sweeping up almost to vertical at the ridge.
For a great hall, measure the distance between the front and back eave purlins and raise the ridge purlin above them by one third of it; for lesser halls, by about a quarter.
rise = ⅓ × depth between eave purlins (halls); ≈ ¼ (+ a small addition) for ting-tang halls
Draw a straight line from the ridge purlin to the eave purlin and lower the first purlin below the ridge from it by one tenth of the rise; from that point draw a new line to the eave purlin and lower the next purlin by one twentieth; continue, halving each time.
drop₁ = H⁄10 · drop₂ = H⁄20 · drop₃ = H⁄40 · …
From the intermediate bracket set of the second bay the rafter ends advance progressively outward, so that at the corner the eave projects further (by 4 cun for a hall of one bay, 5 for three bays, 7 for five bays) and rises with the corner beam.
Give the hipped roof (wudian) to the highest halls, the hip-and-gable (xieshan) to the next, and the gabled roofs, overhanging (xuanshan) and flush (yingshan), to lesser buildings and houses; double the eaves for the very highest.
double wudian > double xieshan > wudian > xieshan > xuanshan > yingshan
Project the eaves from the centre of the eave purlin by 3½ chi for rafters of 3 cun diameter and 4 to 4½ chi for rafters of 5 cun; beyond them add flying rafters projecting six-tenths as far again.
eave projection ≈ 3½–4½ chi · flying rafters = 0.6 × eave projection
Raise a thatched roof by a third and a tiled roof by a quarter: the rougher and more absorbent the covering, the steeper the roof must be.
thatch: rise = ⅓ · tile: rise = ¼
Cite this page Chris Paton, “Qing jǔjià: five-tenths at the eaves, nine at the ridge”, The Textbook of Architecture, https://textbookofarchitecture.com/rule/qing-jujia. Text, drawings and models licensed under CC BY-NC 4.0.